Any input on Cutler-Hammer Starter?

td456

% H- _' _1 T0 @7 c6 [( Q/ b  i; X0 w- s
Two  cutler –hammer advantage  starters are  doing the same thing:
After start 2-3 times, they will quit working, if you toggle the  start and stop buttons on DCS screen  , you will get another 2-3 running before they quit working again.
It is a cycle.

We isolate the network control and use the local start and stop only, the problem remains.
$ a# W  g% D5 [. KSwap one of the defective buckets with a good one, the new bucket works fine.
' b" |6 C2 F" N  Q" n+ V* h7 PThe problem should be inside the bucket.

When the problem happened, we observed that  the contactor has a pulling action but will not seal.
Use a terminating screw divers to push in the contactor, it will not seal either.
" ^' o5 x% ]. j/ W7 d% DConfirm with TECH support this should be a problem with the control circuit board inside the advantage starter, we  bought two new control circuit boards and replaced the old ones, the problem is still the same.

The next thing we can think of  is the coil, we took the coil out to have a close look.
They  have a fork to pinch inside the two leads to make connection, it is not a good design at all. We soldered  the connection and tried again.
7 }# b" n7 J- S/ q# v! ~ It is getting better  this time, we have 7-8 times of running before it quit working.
3 [2 o9 n/ K2 C, w& D; D! l
) x, x; @  w) L  D1 e7 nThe coil should be the problem, we ordered two of them. But it will take 5-6 weeks for us to get them.

9 O; l' ?  k9 I: ]" [4 yDo you guys have any input on this issue?

侠客行

有时候主接触点太脏，也会造成启动器无法正常工作

贾电工

6 ^/ m3 y% N' a$ e
中国人在这里最好说中国话！说英语或想学英语请人到洋人论坛！

homestay

Don't know cutler –hammer advantage  starters very well, but had been worked on AB switch gears for a little while, which has two different coils, one to pull the vacum bottles up which employs larger current, another one uses less current to hold the connection---if the second coil fails, it won't be able to seal the connection.
Since your cutler -hammer works couple times,  I guess 侠客行 is right, or the sealing connection is just worn out.

td456

2# 侠客行
- X7 ]* ]/ }/ a# v# r5 q也想到这一点，不过这是新装的设备。
' z) N/ m, g9 r( C) I6 h6 Q5 d检查过触点没问题。